Float Boost Battery Charger:

BPS FCBC are designed to supply continuous power to the DC load and simultaneously charge the batteries connected. Input supply form 415 V. AC 3 Phase or 220 V. AC 1 Ph. is converted to regulated DC. The charger has two independent systems.

Float Boost charger

BPS FCBC are designed to supply continuous power to the DC load and simultaneously charge the batteries connected. Input supply form 415 V. AC 3 Phase or 220 V. AC 1 Ph. is converted to regulated DC. The charger has two independent systems.

Normally the DC power is supplied to he load by the Float Charger. It also supplies trickle current to the battery to keep it healthy. If the charging current under Float Mode exceeds a set level, Boost charger is switched ON. It supplies Quick charging current to the battery. On battery reaching the set value, the Boost Charger is switched OFF.

Aux: 415V. AC ( 3 Phase) / 240 V (1 Phase) +/- 20 %/ +/- 10%,  50 Hz. +/- 3 Hz. 
Out put: 30 V, 48 V, 110 V and 220 V. DC supply 
Battery Type: Lead Acid / SMF
Indications and instruments: Indications for 3 phase mains supply
 : Float / Boost section
 : AC Volt meter with selector switch 
 : DC Volt meter with selector switch and battery volt
 : DC Amps meter for load
 : DC Amps meter for Charging. 
 : MCB for Mains incoming supply
Protection: MCB for out put load
 : Over load cut out by electronics circuit
 : Over Voltage cut-out by electronics circuit
 : Single phasing, under voltage for mains
 : Heavy duty Sheet Steel Enclosure
  Finished with Powder Coated paint.
Housing and enclosure: : Floor mounting
Mounting: Auto/Manual
Operation: CC/ CV close loop
Control: Full wave half controlled bridge
Rectifier: Fuse protection for each rectifier element
Optional: Fuse failure relay
 : DC Earth Fault Relay
 : Alarm Annunciation
 : Dual Float Charger option
 : Any other as per requirement.  

Related products:

Password :